Screen Printing Chemical Autohaze Gel

Screen Printing Chemical Autohaze Gel

Instructions:

1. Use a release powder solution to remove the photosensitive slurry of the screen (before removing the film, you need to use plate washing water to wash away the remaining ink marks on the screen, otherwise it will be difficult to remove the film)

2. Use a brush to apply the ghost paste on both sides of the screen. Focus on the areas with ghosts. The time should not be too long. Too long time can easily damage the screen. Do not use too much. Excessive application can easily cause the screen to break. .

3. Leave it for about 3-5 minutes, then rinse it with clean water.

Precautions:

This product is highly irritating to the skin and eyes. Pay attention to protection. If it accidentally enters the eyes, rinse with clean water and seek medical treatment promptly. Skin contact

Need to be washed thoroughly with soap